Siemens milltronics BW500 Instruction Manual page 30

To access a parameter directly:
Press
View/Edit Parameter
Enter Parameter Number
Press
P011 Design Rate:
Enter Rate
Or press
P940-2 Load Cell mV Signal Test
mV reading for B
To change a parameter value
P011 Design Rate:
Enter Rate
Press
P011 Design Rate:
Enter Rate
Press
P014 Design Speed
Enter Speed
To reset a parameter value
Press
P011 Design Rate:
Enter Rate
Press
P011 Design Rate:
Enter Rate
Page 24
in sequence.
100.00 kg/h
100.00 kg/h
100.00 kg/h
0.08 m/S
100.00 kg/h
0.00 kg/h
Milltronics BW500 - INSTRUCTION MANUAL
e.g. access P011, design rate
V
For direct access to index parameters
e.g. access P940-2, load cell B mV signal
V
6.78
V
from the view mode
If edit mode is not enabled after pressing
ENTER, Security is locked. Refer to
E
Parameters \ Security Lock (P000)
page 102 for instructions on disabling
Enter the new value
For P001 to P017, ENTER effects the change
V
and scrolls to the next required parameter.
from the edit mode
E
Enter the clear function
Value is reset to factory value.
V
e.g. 0.00 kg/h
on
7ML19985DK03