Test And Diagnostic (P900 - P951) - Siemens milltronics BW500 Instruction Manual

0
Any other value
P792 Hardware Error Count
A count that increments by 1 each time Fail is reported in P790 (Hardware Error).
Values
Range: 0 to 9999
P794 SmartLinx Module Type
This parameter is used to identify the module type when SmartLinx is used. If you are not
using SmartLinx, this parameter is not functional. Please see the associated SmartLinx
instruction manual for a full description of this parameter.
P795 SmartLinx Protocol
This parameter is used to identify the protocol when SmartLinx is used. If you are not
using SmartLinx, this parameter is not functional. Please see the associated SmartLinx
instruction manual for a full description of this parameter.
P799 Communications Control
Assigns programming control through the local keypad (or Dolphin Plus,
P770 = 1), or through a Modbus protocol (P770 = 2 or 3)
Entry:
0 = local
1 = modbus

Test and Diagnostic (P900 - P951)

These parameters are used for test and diagnostic purposes.
Note:
P900 Software Revision
Displays the EPROM (Flash ROM) software revision level.
P901 Memory Test
Tests the memory. Test is initiated by scrolling to the parameter or repeated by 'pressing
enter'
Page 130
* No errors
Error code; provide this code to your Siemens representative for
troubleshooting
Description
Error count; provide this number to your Siemens representative for
troubleshooting.
Milltronics BW500 - INSTRUCTION MANUAL 7ML19985DK03