Set To Default Value (Parameter F4-Xx); External Monitor (Parameter F5-Xx); Error Alarm Operation - Xinje DS2 series Manual

F3-07
F3-08
F3-09
F3-10
F3-11
F3-12
F3-13
F3-14
F3-15
F3-16
※1:
when F3-00=0, no alarm
※2:
when F3-01=0, no warning


Set to default value (parameter F4-XX)

F4-00=1,all parameter will back to default value.
Note: When drive is on, the change cannot be done. The operations must be done when servo
is OFF.


External monitor (parameter F5-XX)

In auxiliary function, choose F5-00, it will show C-OUT. COM1 is available, control panel is
invalid. User can debug the servo through PC.
Press STATUS/ESC to exit.
5. Error alarm operation (parameter E-XX)
When error appears, the drive will enter alarm status and display the alarm no.;
when there is no error, the alarm status cannot see. System error display "E-XXX".
Under the alarm status ,short press ENTER can reset the error. If the power is off
48
The speed when alarming
The internal torque command when alarming
The V-REF value when alarming
The T-REF value when alarming
Alarm/warn code 2 when alarming
Alarm/warn code 3 when alarming
Alarm/warn code 4 when alarming
Alarm/warn code 5 when alarming
Alarm/warn code 6 when alarming
Alarm/warn code 7 when alarming
rpm
%
V
V