Analogue Set Point (Apc); Status Codes; Introduction; Link Layer Status Codes - ABB COM600 User Manual

1MRS755496
Name Type
t TimeStamp
5.2.17.
Name Type
spMag AnalogueValue
5.3.
5.3.1.
5.3.2.
5.3.3.
Station Automation COM600 3.4
DNP 3.0 LAN/WAN Slave (OPC) User's Manual
Value/ Value
range

Analogue set point (APC)

Value/ Value
range

Status codes

Introduction

The following status codes are defined for the DNP slave protocol. Some typical reasons
for some of the status codes are also given.

Link layer status codes

17650 The Data Flow Control ( DFC) bit of the messages from the master is set for
more than 15 seconds.
17651 The DCD or CTS signal or the end of the transmitted message is not received
in correct time.
17652 Timeout while waiting for an acknowledgment to a request.
17654 The application level sends a command before the communication between
the master and the slave is established.
17655 The Data Flow Control bit of the messages from the master is set for too long.
17656 The slave does not receive a reply from the master.
17657 The channel has been set in use.
17658 The channel has been set out of use.
17659 The protocol stack out of buffers error.
17670 The value written to one of the channel properties is incorrect.

Application layer status codes

13901 The value set to a property of the device is incorrect.
Mandat- Protocol informa-
ory/Optional tion element
M <none> | Time of
occurrence
Mandat- Protocol informa-
ory/Optional tion element
M Control Value
OPC data types
V_DATE
OPC data types
VT_R4
49