Connecting The Telephony Gateway - Arris Touchstone TG2492 User Manual

Connecting the Telephony Gateway

WARNING
Risk of injury or equipment damage
Connecting the Telephony Gateway to the home's existing telephone wiring should only be
performed by a professional installer. Physical connections to the previous telephone provider
must be removed and the wiring must be checked; there must not be any voltage. Cancelation
of telephone service is not adequate. Failure to do so may result in loss of service and/or
permanent damage to the Telephony Gateway.
1. Connect one end of the coax cable to the cable outlet or splitter, and the other end to the
Telephony Gateway's Cable connector (6). Tighten the connections by hand, then tighten
an additional 1/8 turn with a wrench.
Release 24 STANDARD 1.2 April 2016
© ARRIS Enterprises, LLC, 2015-2016. All Rights Reserved.
Chapter 4: Installing and Connecting your Telephony Gateway
Touchstone TG2492 Telephony Gateway User Guide
22