Trailing Edge; Vertical Edge - Konica Minolta bizhub 164 Service Manual

11. SERVICE MODE
11.3.15

TRAILING EDGE

A. Use
• To adjust the erase width on the trailing edge of the image by varying the laser emission
timing.
• Used when the PH Unit has been replaced.
B. Procedure
• Set the erase width on the trailing edge of the paper (width A).
• The default setting is 4 mm.
1. Call SERVICE'S CHOICE of SERVICE MODE to the screen.
2. Select [TRAILING EDGE] and press the Menu/Select key.
1
3. Using [ ▲ / ▼ ] key, select the desired setting value.
To make the erase width smaller, decrease the setting value.
To make the erase width greater, increase the setting value.
4. Press the Menu/Select key to validate the setting value selected in step 3.
1
11.3.16

VERTICAL EDGE

A. Use
• To adjust the erase width on both edges of the image (in CD direction) by varying the
laser emission timing.
• Used when the PH Unit has been replaced.
B. Procedure
• Set the erase width on both edges of the paper (width A).
• The default setting is 4 mm.
1. Call SERVICE'S CHOICE of SERVICE MODE to the screen.
2. Select [VERTICAL EDGE] and press the Menu/Select key.
1
3. Using [ ▲ / ▼ ] key, select the desired setting value.
To make the erase width smaller, decrease the setting value.
To make the erase width greater, increase the setting value.
4. Press the Menu/Select key to validate the setting value selected in step 3.
1
90
1
0 mm/1 mm/2 mm/3 mm/"4 mm"/5 mm
0 mm/1 mm/2 mm/3 mm/"4 mm"/5 mm
Field Service Ver. 2.0 Jun. 2010
A
A
A
A0XXF3C502DA
A0XXF3C503DA