Prn Sub (Bypass-C2) - Konica Minolta bizhub 164 Service Manual

11. SERVICE MODE
11.4.10

PRN SUB (BYPASS-C2)

A. Use
• To adjust by varying the starting position of image writing in the sub scanning direction.
• Used when the image on the copy deviates in the sub scanning direction.
• Used when the PH unit has been replaced.
B. Procedure
• Adjust so that width A on the test pattern produced falls within the specified range.
• Specifications: 10 ± 1.5 mm
1. Load the bypass tray with A3/11 x 17 card 2 paper.
2. Enter function of the SERVICE MODE.
3. Select [FUNCTION] → [PRN TEST PATTERN] → [BYPASS] → [TEST PATTERN1].
1
Then, press the Menu/Select key.
This will produce a test pattern.
4. Check to see if width A on the test pattern falls within the specified range.
If width A falls outside the specified range, perform the following steps to make an
adjustment.
5. Select [PRN SUB (BYPASS-C2)] of [ADJUST].
6. Using [ ▲ / ▼ ] key, select the appropriate setting value.
If width A on the test pattern is longer than the specifications, decrease the setting
value.
If width A on the test pattern is shorter than the specifications, increase the setting
value.
7. Press the Menu/Select key to validate the setting value selected in step 6.
1
8. If a single adjustment procedure does not successfully bring width A into the specified
range, repeat steps 5 through 7.
102
1
70 (-4.62 mm) to 130 (+4.62 mm) (1 step: 0.154 mm)
Field Service Ver. 2.0 Jun. 2010
A
A0XXF3C505DA