Hitch Recognition - Lippert Components ground control TT Owner's Manual

NOTE: Once the automatic leveling cycle has been started, it is important that there is no movement in the
trailer until the leveling process is complete. Failure to remain still during the leveling cycle could
have an effect on the performance of the leveling system.
NOTE: Sequence may vary slightly based on the height of the trailer coupler prior to leveling.
6.
When the Auto Level Sequence begins:
D. The system checks that the rear jacks are retracted.
E.
The Power Tongue Jack may adjust depending on the orientation of the trailer.
F.
Front jacks will extend until movement of the trailer is sensed.
G. The Power Tongue Jack will then retract.
H. The front jacks will extend/retract near level.
I.
Rear jacks will extend and ground.
J.
Trailer will level front-to-back and then side-to-side.
K. The Auto level Sequence will ground all jacks to ensure all foot pads are on the ground.
L. The Auto Leveling sequence is complete when the OneControl Touch Panel indicates, "Auto Level
Success."
NOTE: If the AUTO LEVEL sequence does not perform as described above, locate the OneControl Touch
Panel or use the OneControl App to place the system in Manual Mode. Test that the jacks operate
correctly by pushing their corresponding buttons on the OneControl Touch Panel or App; e.g.,
"FRONT" button operates only the front jacks, etc. (See "Operation - OneControl Touch Panel" or
"Operation - OneControl App" in this manual).

Hitch Recognition

1.
Press the "ON/OFF" button to turn the
OneControl Touch Panel on (Fig. 8A).
2. Press "MyRV Control Panel" on the main
screen (Fig. 5A).
3.
Press the "Leveler" icon (Fig. 6A).
4.
Press "AUTO HITCH" (Fig. 8B).
A. Rear jacks will retract.
B. The Power Tongue Jack will extend to
the ground.
C. Front leveling jacks will retract.
D. The tongue jack will then adjust the
height of the front of the trailer coupler
to the point at which the "AUTO LEVEL"
button was most recently pressed.
5.
Back the tow vehicle into position to align the tow vehicle hitch and trailer coupler with each other.
NOTE: If using the OneControl Touch Panel and the hitch is not visible a second person will be needed to
monitor the operation of the hitching process.
6.
Press "RETRACT" button, then press the "FRONT" button to retract the tongue jack until the coupler
sets into position on top of the tow vehicle hitch.
7. Latch the tow vehicle hitch and connect any wires, chains or sway control that may be equipped
between the tow vehicle and trailer.
NOTE: Press the "RETRACT" button and then press and hold the "FRONT" button until the Power Tongue
Jack fully retracts.
NOTE: To utilize the Power Tongue Jack for the hitching process see "Operation - Power Tongue Jack."
Rev: 11.13.2017
Page 10
Fig. 8
A B
Ground Control TT Leveling OCTP Owner's