GE C60 Instruction Manual page 137

CHAPTER 4: INTERFACES
Use the tool EXACTLY as outlined as follows, with the printed side containing the GE part number facing the user.
The label package shipped with every C60 contains the three default labels, the custom label template sheet, and the label
removal tool.
If the default labels are suitable for your application, insert them in the appropriate slots and program the LEDs to match
them. If you require custom labels, use the following procedures to remove the original labels and insert the new ones.
To set up and use the label removal tool:
1. Bend the tabs at the left end of the tool upwards as shown.
Bend the tab at the center of the tool tail as shown.
To remove the LED labels from the C60 enhanced front panel and insert the custom labels:
1. Use the knife to lift the LED label and slide the label tool underneath. Ensure that the bent tabs are pointing away from
C60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUAL
FRONT PANEL INTERFACE
4-25
4