GE C60 Instruction Manual page 55

CHAPTER 3: INSTALLATION PANEL CUTOUTS
The torque used to connect the terminal blocks to the back of the relay chassis (screws a, b, c shown) is 9 inch-pounds. For
the connections to the terminal blocks (rows 1 to 8), use a minimum of 17 inch-pounds. During manufacturing, the power
supply and CPU modules are installed in slots B and D of the chassis with 13 inch-pounds of torque on the screws at the
top and bottom of the modules.
3
C60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUAL 3-9