GE C60 Instruction Manual page 139

CHAPTER 4: INTERFACES
4. Slide the new LED label inside the pocket until the text is properly aligned with the LEDs, as shown.
To remove the user-programmable pushbutton labels from the C60 enhanced front panel and insert the custom labels:
1. Use the knife to lift the pushbutton label and slide the tail of the label tool underneath, as shown. Ensure that the bent
tab points away from the relay.
2. Slide the label tool under the user-programmable pushbutton label until the tabs snap out as shown. This attaches the
label tool to the user-programmable pushbutton label.
C60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUAL
FRONT PANEL INTERFACE
4-27
4