GE C60 Instruction Manual page 282

PRODUCT SETUP
PUSHBTN 1 AUTORST DELAY
mode.
PUSHBTN 1 REMOTE
operation from the operand assigned to the
— This setting assigns the FlexLogic operand serving to inhibit user-programmable pushbutton operation
PUSHBTN 1 LOCAL
from the front panel pushbuttons. This inhibit functionality is not applicable to pushbutton autoreset.
PUSHBTN 1 DROP-OUT TIME
programmable pushbutton active status after the front panel pushbutton has been released. When activated remotely,
this setting specifies the entire activation time of the pushbutton; the length of time the operand selected by
remains on has no effect on the pulse duration.
PUSHBTN 1 LED CTL
setting is "Off," then LED operation is directly linked to the
PUSHBTN 1 MESSAGE
programmed in the
off message that is programmed in the
When set to "Disabled", user-programmable pushbutton messages do not display. Otherwise the on message displays
when the user-programmable pushbutton becomes activated, and if in the "Latched" mode the off message displays when
the user-programmable pushbutton becomes deactivated.
When set to "Normal", the duration the message displays is as specified by the
When set to "High Priority", the duration of the off message is as specified by the
message is displayed as long as the user-programmable pushbutton is activated. While activated, target and other
messages are suppressed. To allow front panel keypad operation, when a keypad button is pressed the message is
5 supressed for 10 seconds.
PUSHBUTTON 1 EVENTS
event into the event recorder.
The figures show the user-programmable pushbutton logic.
5-114
— This setting specifies the time delay for automatic reset of the pushbutton when in "Latched"
— This setting assigns the FlexLogic operand serving to inhibit user-programmable pushbutton
PUSHBTN 1 SET
— This setting applies only to "Self-Reset" mode and specifies the duration of the user-
— This setting assigns the FlexLogic operand serving to drive the front panel pushbutton LED. If this
— This setting controls the behavior of the user-programmable pushbutton on message that is
and
PUSHBTN 1 ID PUSHBTN 1 ON TEXT
PUSHBTN 1 ID
— If this setting is enabled, each user-programmable pushbutton state change is logged as an
or settings.
PUSHBTN 1 RESET
operand.
PUSHBUTTON 1 ON
settings, and the behavior of the user-programmable pushbutton
and settings.
PUSHBTN 1 OFF TEXT
FLASH MESSAGE TIME
FLASH MESSAGE TIME
C60 BREAKER PROTECTION SYSTEM – INSTRUCTION MANUAL
CHAPTER 5: SETTINGS
PUSHBTN 1 SET
setting.
setting, but the on