Dome Thermometer & Smoke Stack - Pit Boss PB820FBC Instructions And Recipes Manual

INSTALLATION STEPS
• Insert one screw (A) from inside the lid, through the hole
provided in the lid.
• Place one bezel (6) over the screw, then lin-up the handle (5)
with the threaded end of the screw.
• Hand start the screw into the handle
• Repeat procedure for other end of handle
• Using your wrench securely tighten ALL screws (A)
ASSEMBLING THE DOME
THERMOMETER
Parts Needed:
7 - Dome Thermometer
INSTALLATION STEPS
• The thermometer comes complete with its own threaded nut
already installed on the thermometer.
• Simply spin off the threaded nut, and insert the thermometer
through the hole provided in the top of the hood. Firmly hand
tighten the nut back onto the thermometer.
Note: Take care not to turn the face of the thermometer. This will
result in incorrect readings.
ATTACHING THE SMOKE STACK
Parts Needed:
17 - Smoke Stack
- Smoke Stack Gasket
Hardware Required:
Screw 1/4" - 20* 3/5" x2 (AA)
INSTALLATION STEPS
• Using the 2 screws (AA) insert those through the stack section,
through the gasket, then finally through the barrel end.
• Hand start, then secure in place using your Phillips Screwdriver
Note: DO NOT lower the chimney cap tight to the chimney stack. You
must allow air to escape.
9