Table of Contents
Advertisement
remove this bolt
wiring harness
i818-511EX
U
SE THE
unplug this
N
ON
connector
The ignition must be turned OFF before
installation.
1
2
3
4
5
6
Remove the battery completely from the bike.
7
Route the stock wiring harness under the right
hand frame tube as shown in Figure B.
8
Route the PCIII USB EX male connector under
PCIII USB EX
the right hand frame tube as shown in
connector
Figure C.
9
Reinstall the battery.
stock connector
F
I
OLLOWING
NSTRUCTIONS FOR
-ABS M
ODELS
Remove the seat.
Remove the right hand side cover.
Unplug the stock wiring harness from the ECM
as shown in Figure A.
Remove the bolt securing the ECM tray as
shown in Figure A.
Remove the ECM tray and lift the ECM and tray
out of the way.
2008 Harley Davidson Touring - PCIII USB EX - 2
Advertisement
Table of Contents
Need help?
Do you have a question about the Power Commander III and is the answer not in the manual?
Questions and answers