Advertisement
Parts List
1
Power Commander
1
USB Cable
1
CD-ROM
1
Installation Guide
1
Power Adapter
2
Power Commander Decals
2
Dynojet Decals
2
Velcro
Strip
®
1
Wire tap
1
Alcohol Swab
1
O2 eliminator
The ignition MUST be turned
OFF before installation!
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
i333-411
www.powercommander.com
2 0 0 7 S u z u k i G S X R 1 0 0 0
I n s ta l l a t i o n I n s t r u c t i o n s
Button Adjustment Display
Faceplate Buttons
Expansion Port
USB Port
2007 Suzuki GSXR1000 - 1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dynojet Power Commander III
Summary of Contents for Dynojet Power Commander III
-
Page 1: Parts List
You can also download the Power Commander software and latest maps from our web site at: www.powercommander.com PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com i333-411 www.powercommander.com 2007 Suzuki GSXR1000 - 1... - Page 2 Remove the seats. Prop the fuel tank up. Lay the PCIII in the tail section and route the PCIII harness towards the front of the bike (Fig. A). Route the PCIII harness along the left Ground wire hand side of the bike. PCIII harness Attach the ground wire from the PCIII...
- Page 3 Follow the wires out of the exhaust to the stock wiring harness. Unplug the sensor from the stock wiring harness. Plug the Dynojet O2 eliminator into Grey wire the stock wiring harness. The stock from PCIII sensor is no longer needed.
Need help?
Do you have a question about the Power Commander III and is the answer not in the manual?
Questions and answers