Advertisement
New Accelerator Pump feature for all
Power Commander III USB units
Dynojet is pleased to announce a new
"Accelerator Pump" feature for all USB
Power Commanders. This is a FREE
upgrade that can be installed into any
USB Power Commander.
Step 1 - Download the Accelerator
Pump utility file from
www.powercommander.com.
Step 2 - Connect to the Power
Commander and run the utility
Step 3 - Experiment with the settings to
match your riding style.
You can adjust:
A) The amount of fuel to add
B) The number of engine revolutions
during which fuel is added
C) The sensitivity of throttle move-
ment under which the accelera-
tor pump is activated
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 (800) 992-4993 www.powercommander.com
Installation Instructions
Accelerator Pump For All PCIII USB Units - 1
Advertisement
Table of Contents
Related Manuals for Dynojet Power Commander III
Summary of Contents for Dynojet Power Commander III
-
Page 1: Installation Instructions
C) The sensitivity of throttle move- ment under which the accelera- tor pump is activated Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 (800) 992-4993 www.powercommander.com Accelerator Pump For All PCIII USB Units - 1... - Page 2 F r e q u e n t l y A s k e d Q u e s t i o n s Q. I have a Power Commander III. Can I use this utility? A. No, the Power Commander II and III hardware can- not support this feature.
Need help?
Do you have a question about the Power Commander III and is the answer not in the manual?
Questions and answers