Advertisement
Parts List
1
Power Commander
1
USB Cable
1
CD-ROM
1
Installation Guide
1
Power Adapter
2
Power Commander Decals
2
Dynojet Decals
2
Velcro
Strip
®
1
Alcohol Swab
The ignition MUST be turned
OFF before installation!
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com
i420-411
www.powercommander.com
2 0 0 6 - 2 0 0 7 Ya m a h a F Z 1
I n s ta l l a t i o n I n s t r u c t i o n s
Button Adjustment Display
Faceplate Buttons
Expansion Port
2006-2007 Yamaha FZ1- PCIII USB - 1
USB Port
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Dynojet Power Commander III
Summary of Contents for Dynojet Power Commander III
-
Page 1: Parts List
Commander software and latest maps from our web site at: www.powercommander.com PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 (800) 992-4993 www.powercommander.com i420-411 www.powercommander.com 2006-2007 Yamaha FZ1- PCIII USB - 1... - Page 2 Remove the main seat and the passen- ger seat. Unplug this connector Prop the front of the fuel in the up position. Lay the PCIII in the tail section tem- porarily. Route the PCIII harness under the tail section and go towards the front of the bike.
- Page 3 Attach the ground wire from the PCIII to the negative side of the battery Ground wire from the PCIII. (Fig. D). Install the PCIII in the rear section of the trunk (Fig. E). This bike does not have a flat surface to allow you to use the supplied vel- cro.
Need help?
Do you have a question about the Power Commander III and is the answer not in the manual?
Questions and answers