Changing The Print Roller - CAB MACH 4.3S/200B Service Manual

2 Changing Assembly Parts
12
2.6

Changing the Print Roller

Fig. 6 Changing the print roller
1. Open the cover and fold the control panel down. Push the unlocking mechanism and fold the printing module up.
2. Through the openings on both sides, push the pressure points (1) until the print roller assembly (2) snaps out of
the locking mechanism. This action lifts the print roller assembly (2) a little.
3. Lift the unlocked pressure roller assembly (2) out of the device.
4. Remove the roller locking mechanism (6) from the print roller (5) and remove the dispensing edge (3) from the
roller locking mechanism (4).
5. Insert the dispensing plate (3) into the roller locking mechanism (4) of the new print roller and push the new roller
locking mechanism (6) onto the print roller and the dispensing edge.
!
Attention!
When exchanging the control panel B or P with control panel C ( 2.2 on page 7) the dispensing edge
must be removed prior to the exchange.
 Connect the roll retainer (5) to the pressure roller (4) and place the assembly group, without the
dispensing edge (3), into the printer.
Follow the reverse order to achieve the opposite effect.
4. Insert the pressure roller assembly group (2) into the printer and evenly push down to lock it into place.
5. Lock the printing and control modules.
1 2
6 5
3 4
12