Changing The Blade Of The Cutter Unit - CAB MACH 4.3S/200B Service Manual

2 Changing Assembly Parts
16
2.10

Changing the Blade of the Cutter Unit

1
Fig. 10 Changing the blade of the cutter unit
Danger!
!
Danger of lacerations!
 Do not touch the blade without protective measures.
1. Fold down the control panel (1).
2. Release the cutter unit (3) by undoing the brackets (2) and fold it upwards.
3. Loosen the three screws (4) and the washers (5) and remove the bottom blade.
4. Loosen the three screws (8) and take off the top blade and the material guide (10).
5. Screw a new top blade and paper guide (11) to the base plate.
6. Screw a new bottom blade to the bracket (12).
i
Note!
If only the top blade (9) needs to be replaced the camp (12) with the bottom blade (6) can be hinged up from
the top blade by turning the screw (7) with a hexagonal key 2.5 mm.
Danger!
!
Danger of lacerations and crushing limbs!
 While folding the panel up or down particularly when the panel is folded down the springs at the clamp
are under high tension. Do not reach between the blades.
2
2 3
8 9 10
4 5 6
11 12
7
16