Table of Contents
Advertisement
3.3.
3.3.1.
•
•
•
34
How to use band saw
Cutting
Picture
7. For Practix 285.230 G manual
Turn switch no. 3 to adjust speed of saw arm
falling.
When material is cut, limit switch stops drive of
saw band.
To continue in cutting please repeat points
1–7.
What to do
1.
Insert the material to the vice.
2.
Shift the material in claimed length of
cutting.
3.
Fix the material by means of clamping
wheel. Come with vice approximately 3
mm to material.
Note: Turning the wheel in clockwise
direction the vice is tightened. Turning the
wheel in counter clockwise direction the vice
is loosened.
4.
Vice and clamp the material by means of
detent lever
5.
Choose desired cutting speed by
turning the switch on the motor.
6.
Check the right and tight fixation of
material once again.
7. For Practix 285.230 G pulldown
•
Security circuit must be turn ON by button on pos.
4 before cutting begin.
•
Security circuit must be switched ON after every
disconnection from electrical network
•
Start the band saw by pressing button no. „3"
(START) positioned on operating lever. If button
no. „3" is loosen, driving stops.
•
Is necessary to lead the arm to cut manually.
•
To continue in cutting, repeat p. 1–7.
Manual version:
1.03/ Feb. 2010
Manual rev.:
1
Advertisement
Table of Contents
