Table of Contents
Advertisement
3.1.
Control elements for Practix 285.230 G Manual
Control elements
3.2.
Control elements for Practix 285.230 G Pulldown
Control elements
Description
1.
TOTAL STOP button
In emergency causes the machine must
be immediately switched off.
Attention! By pressing Total Stop button
does not stop sinking of the saw arm!
2.
Switch of the cutting speed
Choice of the cutting speed during
-1
cutting (35 or 72 m. min
).
3.
Adjustment of saw arm falling
Adjust speed of saw arm sinking during
cutting. Turning the wheel switch on
the cylinder smoothly changes saw arm
sinking speed. Position 0 stops saw arm
sinking. Position 1 is for lowest sinking
speed and position 4 is for highest
sinking speed.
Description
1.
Off saw band drive
Position 0 off saw band drive.
Attention! Position 0 does not
disconnect saw from electrical network
2.
Switch of the cutting speed
Choice of the cutting speed during
-1
cutting (35 or 72 m. min
).
4
Security circuit
Button on top of switch box turn on
security circuit. Security circuit must be
switched on before cutting begins after
saw was disconnected form electrical
network.
3.
START AND STOP
Button starts and stops saw band drive.
33
Advertisement
Table of Contents
