Table of Contents
Advertisement
3.4.3.
Bundle material cutting
If you want to cut the material in the bundle, there are suggestions for the positioning
of bundles
Round material bundle:. Take care especially with round material that the bars are put
according to the picture. If the bars are put differently, you may have problems with
movement.
Always weld the material at the rear end of the bundle to secure it from moving.
Before welding always, switch the machine off at the main switch! The magnetic fields,
which often occur during welding, may damage the controls!
Square material bundle:
Attention!
Not all shapes of material are suitable for cutting in the
bundle. Follow recommendations of your saw band supplier for
placing material into bundle.
37
Advertisement
Table of Contents
