Welch Allyn Connex Service Manual page 59

Service manual
Message
Patient ID required to send data.
Patient list is full. Delete some
patients to add more.
Stop intervals to select new
patient.
No connection for send.
Unable to identify clinician.
Unable to retrieve list.
Network messages
Message
Lost connectivity with host.
Possible cause
The configuration requires a patient ID to send
data
The maximum number of patients was exceeded Delete a patient from the list to
The device is set to take interval readings
No connectivity is available to support sending
data manually or automatically sending data on
manual save
The clinician ID or password is incorrect
The device is unable to retrieve a patient list
from the network
Possible cause
The central station or other host
application has stopped running or
is not operating properly
Troubleshooting 55
Suggested action
management
tab in
Advanced settings.
Add a patient ID.
add a new patient.
Stop intervals before changing
the patient.
Check network connection.
Check Radio Configuration
settings.
Confirm the clinician ID and
password (if applicable), and
retry.
Check the network connection.
Check the Radio Configuration
settings.
Verify that the server is available.
Suggested action
Confirm that the host application
is running properly.