Vertical Service Announcement Codes - Cisco IP Phone 6851 Administration Manual

Cisco IP Phone Web Page
Parameter
Feature Dial
Services Codes

Vertical Service Announcement Codes

Parameter
Service Annc Base Number
Service Annc Extension Codes
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
178
Description
These codes tell the phone what to do when the user is listening to the first or second
dial tone.
One or more *code can be configured into this parameter, such as *72, or
*72|*74|*67|*82, and so forth. The maximum total length is 79 characters. This parameter
applies when the user has a dial tone (first or second dial tone). Enter *code (and the
following target number according to current dial plan) entered at the dial tone triggers
the phone to call the target number prepended by the *code. For example, after user
dials *72, the phone plays a prompt tone awaiting the user to enter a valid target number.
When a complete number is entered, the phone sends a INVITE to *72<target_number>
as in a normal call. This feature allows the proxy to process features like call forward
(*72) or BLock Caller ID (*67).
The *codes should not conflict with any of the other vertical service codes internally
processed by the phone. You can empty the corresponding *code that you do not want
to the phone to process.
You can add a parameter to each *code in Features Dial Services Codes to indicate
what tone to play after the *code is entered, such as *72'c'|*67'p'. Below are a list of
allowed tone parameters (note the use of back quotes surrounding the parameter without
spaces)
• c = Cfwd Dial Tone
• d = Dial Tone
• m = MWI Dial Tone
• o = Outside Dial Tone
• p = Prompt Dial Tone
• s = Second Dial Tone
• x = No tones are place, x is any digit not used above
If no tone parameter is specified, the phone plays Prompt tone by default.
If the *code is not to be followed by a phone number, such as *73 to cancel call
forwarding, do not include it in this parameter. In that case, simple add that *code in
the dial plan and the phone sends INVITE *73@..... as usual when user dials *73.
Description
Defaults to blank.
Defaults to blank.