Loading/Updating The Software - Bosch SPS40C12GB Repair Instructions

Repairs
6.37

Loading/updating the software

Required tools:
? UDA with cables and adapters
? Computer
? I-Service Software
Prerequisite:
• Appliance has been disconnected from the mains.
• Power module integrated in the appliance or connected in the logistics
programming station.
• Outer door (operating electronics) or the right-hand side panel (power module)
have been removed.
Exposed, live components!
Death from electric shock.
► Disconnect the appliance from the power supply.
► Do not touch housing, frame or components.
► If running tests while the power is on, always use a residual
current circuit-breaker.
► Ensure that the resistance of the protective conductor does not
exceed the standardised value.
Risk of short circuit
Death by electrocution
► Connect the UDA only with the plugged in coding frame [ 15000166] to the
upper side of the module.
2016-03-02 / DIS 840_58300000176874_ara_en_c
Mains voltage on the ground cable of the bus system!
Destruction of the operating module or the power module
► Disconnect the appliance from the mains before disconnecting / connecting
plug contacts.
► Do not connect the Y cable to the power module.
6.37.1 Procedure for installing the software:
1. Disconnect the appliance from the mains.
2. Connect the UDA to the appliance (either on the operating module or on the
power module).
3. Connect the UDA to the computer.
4. Connect the appliance to the power supply.
5. Connect the appliance.
6. Ensure that no program starts.
7. Start the iService on the computer and
order (Page 123)
8. Perform hardware reset. The appliance must be disconnected from the mains
for at least 10 seconds first (all LEDs on the operating module are off).
9. Disconnect the UDA from the appliance.
10. Connect the appliance to the power supply.
11. Perform a software reset (press and hold down the Start button for a period of
3 seconds).
12. Switch off the appliance at the power switch.
Copyright by BSH Hausgeräte GmbH
install the software in the specified
until notification appears of successful installation.
Page 121 of 157