Changing Customer Setting - Key Layout Fully Integrated Without Display (Optional) - Bosch SPS40C12GB Repair Instructions

Repairs
6.21 Changing customer setting - Key layout fully
integrated without display (optional)
recruitment Display
Water hardness H:00 - H:07
Intensive drying d:00 - d:01
Rinsing r:00 – r:06
Auto Power Off P:01 - P:02
Table 7: Overview of customer settings
Prerequisite:
• Appliance is switched on.
• No program has been started. No timer programming is activated (Perform
reset + press "Off/On" button).
• Door has been opened.
6.21.1 Key layout fully integrated without display
Fig. 9: Control panel without display on fully integrated models
►
2016-03-02 / DIS 840_58300000176874_ara_en_c
Value range Factory settings
8 ranges H:04
Switching on and d:00
off
Switching on and r:05
off
P:00 (off) P:01
P:01
(off after 1 min)
P:02
(off after 120 min)
Copyright by BSH Hausgeräte GmbH
6.21.2 Setting the water hardness
1. Hold down the button B.
2. Additionally press the "Start" button D until the display and the Low salt
indicator flash.
3. Release the buttons. (The Low salt indicator flashes and the current setting is
displayed).
4. To change the setting, press the button B until the required value is displayed.
6.21.3
°dH Hardness mmol/l
category
0 - 6 Soft 0 - 1.1
7 - 16 Medium 1.2 - 2.9
17 - 21 Hard 3 - 3.7
22 - 35 Hard 3.8 - 6.2
Table 8: Selection options
►
6.21.4 Storing the settings
► The settings are stored by pressing the "Start" button D.
Level Button 1 Button 2 Button 3
0 (off)
1
2
3
Page 89 of 157