Time Leaps In Remaining Time - Bosch SPS40C12GB Repair Instructions

Fault diagnosis
Fault

Time leaps in remaining time

2016-03-02 / DIS 840_58300000176874_ara_en_c
Possible cause
The screws on the inner door are not fully
screwed in.
Baskets badly loaded
Door lock does not close with enough
force.
Door seal is not correctly mounted or has
slipped.
Feed pipe or riser was installed incorrectly. ► Check that the components are correctly seated.
Additional rinse cycle to clean the water
storage tank. Only applies to appliances
with a water storage tank
Additional regeneration cycle. Only applies
to appliances with a water-softening sys-
tem.
Minimal deviations due to various factors
such as loading, soiling, ambient tempera-
ture, ... etc.
Copyright by BSH Hausgeräte GmbH
Troubleshooting
► Insert the screws straight and tighten them fully.
► Check the loading of the baskets. Items of tableware may not protrude from the
basket. Leave the area around the handle of the basket clear.
► Advise customer:
Explain to the customer how to correctly load the tableware (see instruction
manual).
► Replace the upper trim.
► Replace the door lock.
► Check the position of the door seal and correct it. The sealing lip faces inwards.
Press the seal fully into place.
► Replace defective components.
► No troubleshooting required.
► Advise customer:
The water storage tank is cleaned automatically every 15-20 washing cycles.
► No troubleshooting required.
► No troubleshooting required.
Page 10 of 157