Grizzly G0772 Owner's Manual page 73

Using the Auxiliary Fence & Push
Block
1.
Place auxiliary fence on table and clamp
it to fence at both ends, then adjust dis-
tance between auxiliary fence and blade—
this determines how wide workpiece will be
ripped (see Figure 148).
Auxilliary Fence
Blade
Workpiece
Cutting Width
Figure 148. Adjusting ripping distance between
blade and auxiliary fence.
2. Postiion blade guard according to height of
workpiece.
3. Place workpiece 1" behind blade and evenly
against table and auxiliary fence.
Auxilliary Fence
Blade
Workpiece
Push Stick
for Side
Support
Blade Path
Figure 149. Push block in position to push
workpiece through blade.
Model G0772 (Mfd. Since 05/15)
4. Turn saw ON, then begin ripping workpiece
using a push stick for side support.
5. As workpiece nears end of cut, place push
block on auxiliary fence with lip directly
behind workpiece, then release push stick
just before blade.
6.
Guide workpiece rest of way through cut with
push block, as shown in Figure 150.
Release
Push Stick
Before Blade
Figure 150. Ripping with push block.
Turn OFF the saw and allow blade to come
to a complete stop before removing cut-off
piece. Failure to follow this warning could
result in serious personal injury.
Push
Block
Lip
Blade Path
Push
Block
-71-