Grizzly G0772 Owner's Manual page 54

8. Install scoring blade set, flange, and arbor nut
in reverse order from removal, making sure
upper blade teeth face LEFT (see Figure 94),
then tighten arbor nut.
Upper Teeth
Facing Left
Flange
Arbor
Nut
Figure 94. Scoring blade order of assembly.
9.
Align scoring blade with main blade, as
instructed in next subsection.
Aligning Scoring Blade
The scoring blade must be aligned with the
main blade to properly prevent tear-out. Before
attempting to align the blades with each other, the
kerf thickness of the scoring blade must match
that of the main blade.
To align scoring blade:
1.
Adjust main blade tilt to 0°, then raise both
blades all the way up.
2.
Raise blade guard all the way and move it
away from blade.
3.
Loosen jam nut and remove outer rip fence
stop screw shown in Figure 95. This allows
rip fence to be positioned next to the blade.
Jam
Outer
Nut
Stop Screw
Figure 95. Location of rip fence jam nut and
outer stop screw.
-52-
4.
Figure 96. Rip fence against main blade as a
Arbor
5.
Figure 97. Scoring blade alignment controls.
6.
7.
8.
Move rip fence against main blade (or scoring
blade), as shown in Figure 96.
guide for aligning scoring blade.
Use "+" and "-" keys on control panel to
adjust scoring blade (see Figure 97) so that
rip fence can touch both scoring blade and
main blade evenly.
Scoring Blade
Left
Re-install stop screw removed in Step 3.
Reposition blade guard over blade.
Lower scoring blade to correct height. Perform
test cut, then make any final adjustments, if
necessary.
Model G0772 (Mfd. Since 05/15)
Rip Fence
Scoring Blade
Right