Grizzly G0772 Owner's Manual page 36

48. Unlock slide lock handle (see Figure 52).
Carefully slide rip fence rail onto clamping
plate. Gap between bottom of rip fence and
table should be even from front to back.
Slide Lock
Handle
Clamping
Plate
Figure 52. Installing rip fence.
—If gap is not even from front to back, or if
fence contacts table, lift rip fence base off
of table. Loosen lock nut (see Figure 53)
and adjust cam nut to raise or lower fence
height above table.
Cam Nut Wheel
Figure 53. Rip fence height adjustment wheel.
49. Place fence back on table and re-check gap.
Repeat adjustments from previous step as
necessary, then tighten lock nut on wheel
and secure rip fence with slide lock handle.
-34-
Rip Fence
Base
Rip Fence
Lock Nut
50. Slide rip fence until it almost touches blade
teeth, then lock fence position.
51. Use a feeler gauge (see Figure 54) to verify
gap between teeth and rip fence at front and
back end of blade are the same.
— If gap is not the same, adjust jam nuts and
hex nuts on stud at right end of rail until
gap is even.
Figure 54. Using feeler gauge to verify fence is
even from front to back.
52. Move rip fence out of the way.
53. Turn outer hex nut on center stud until flat
washer just contacts front of table, as shown
in Figure 55.
Outer Hex Nut
Figure 55. Outer hex nut and flat washer
positioned on center rail stud.
Model G0772 (Mfd. Since 05/15)
Flat
Washer