Grizzly G0772 Owner's Manual page 35

44. The rip fence rail is pre-assembled with
three rail studs and accompanying hardware.
Remove (1) hex nut and (1) flat washer from
end of each stud, as shown in Figure 48.
Figure 48. Removing rip fence rail hardware to
prepare for installation.
45. Adjust jam nuts, hex nuts, and flat washers
on two outer studs so flat washers are 2
from rail (see Figure 49). Adjust fasteners on
center stud so flat washer is 2" from rail.
Jam Nut
Rail
2 ⁄
1
2
Figure 49. Flat washer on outer stud adjusted
correct distance from rail.
Model G0772 (Mfd. Since 05/15)
Hex Nut Flat Washer
"
46. Insert studs into tables as shown in Figure
50, then re-install hardware removed in Step
44 on outer studs and tighten. Position end
stop pointing up.
End Stop
⁄ "
1
2
Figure 50. Installing rip fence rail.
47. Slide rip fence base onto rip fence rail. Adjust
cams to highest position (see Figure 51).
Figure 51. Rip fence cams adjusted to highest
positions.
-33-