Grizzly G0772 Owner's Manual page 31

19. Install extension table supports onto cabinet
with (4) pre-installed M8-1.25 x 20 hex bolts
and (4) flat washers, as shown in Figure 30.
Finger-tighten only, for now.
Extension Table
Supports
Figure 30. Extension table supports installed.
20. Secure each extension table support to large
extension table with two studs. Thread includ-
ed hex bolt through each stud (see Figure
31) into extension table.
Large
Extension
Table
Figure 31. Table support secured to extension
table with studs.
21. Tighten hex bolts that secure supports to
cabinet.
Model G0772 (Mfd. Since 05/15)
x 4
x 4
Extension Table
Support
22. Place straightedge across cast iron table and
adjust hex nuts on studs (see Figure 32) to
align top of large extension table with top of
cast iron table.
Figure 32. Hex nuts used to align large
extension table with cast iron table.
23. Attach lower support arm to saw cabinet with
(4) M10-1.5 x 25 hex bolts, (4) 10mm lock
washers, and (4) 10mm flat washers.
Lower Support
Arm
Figure 33. Blade guard lower support arm
attached to saw cabinet.
x 4
-29-