Grizzly G0772 Owner's Manual page 62

To perform miter cut:
1. Mount miter fence onto sliding table (refer to
Step 37 on Page 32).
2.
Position fence at desired angle and use
clamp plate ratcheting handle to lock fence in
place (see Figure 122).
Figure 122. Miter fence set to 45˚ mark on the
miter fence scale.
3. Loosen lock knobs that secure flip stop in
miter fence (see Figure 123).
Lock Knobs
Flip Stop
Figure 123. Location of flip stop lock knobs.
4.
Position flip stop to left of blade according to
length of workpiece.
-60-
Clamp Plate
Ratcheting
Handle
Miter Fence
— If desired cut-off length to left of blade is
between 9 ⁄ " and 45", then insert short
1
2
end of flip stop into miter fence body (see
Figure 124).
Figure 124. Flip stop installation for cut length
between 9
— If desired cut-off length to left of blade
is between 45" and 83", then insert long
end of flip stop into miter fence body (see
Figure 125).
Figure 125. Flip stop installation for cut length
between 45" and 83".
5.
Position blade guard to correct height for your
workpiece.
6.
Load workpiece onto table saw. Setup should
look similar to Figure 120 or 121 on Page on
this page.
7.
Once all necessary safety precautions have
been taken, perform cutting operation.
Model G0772 (Mfd. Since 05/15)
⁄ " and 45".
1
2