Grizzly G0772 Owner's Manual page 34

35. Install both flip stops on crosscut fence by
unlocking extension piece lock knob, sliding
extension piece out, sliding clamp bar on bot-
tom of flip stops into fence (see Figure 43),
then tightening lock knob.
Outside Flip Stop
Clamp Bar
Figure 43. Flip stops installed on crosscut fence.
36. Install wood end-cap onto crosscut fence with
(4) #6 x 1" tap screws and (4) 4mm flat wash-
ers, as shown in Figure 44.
Figure 44. Wood end-cap installed on crosscut
fence.
37. Place miter fence bracket (see Figure 45)
onto sliding table rail. Slide miter fence along
sliding table rail and thread pivot knob into
block (see Figure 45).
Pivot Knob
Block
Rail
Miter Fence
Bracket
Figure 45. Miter fence installed on sliding table.
-32-
Lock Knob
Inside Flip
Stop
x 4
Pivot Knob
38. Install push handle on sliding table by loos-
ening lock knob on push handle, installing
handle onto right end of sliding table rail, then
tightening knob (see Figure 46).
Rail
Figure 46. Push handle installed on sliding table
39. Install tool holder on right side of saw cabinet,
as shown in Figure 47, with included M6-1 x
12 button head cap screws.
Figure 47. Tool holder installed on saw cabinet.
40. Connect saw to power (refer to Power
Connection on Page 37).
41. Perform Test Run procedure (refer to Page
38).
42. Set blade to 0° using control panel (see
Figure 3 on Page 5), and then raise blade all
the way up.
43. DISCONNECT MACHINE FROM POWER!
Model G0772 (Mfd. Since 05/15)
Lock Knob
rail.
x 2