Grizzly G0772 Owner's Manual page 32

24. Attach upper support arm to lower support
arm with (2) M10-1.5 x 25 hex bolts, (2)
10mm lock washers, and (2) 10mm flat wash-
ers, as shown in Figure 34.
25. Remove (4) pre-installed M8-1.25 x 20 cap
screws and (4) 8mm lock washers from end
of upper support arm (see Figure 34).
Upper
Support
Arm
Figure 34. Upper support arm connected to
lower support arm.
26. Secure swing arm to upper support arm with
four cap screws and lock washers removed in
previous step, as shown in Figure 35.
Upper Support Arm
x 4
Figure 35. Swing arm mounted to upper support
arm.
-30-
Lower
x 2
Support
Arm
Swing Arm
27. Push slide lock on blade guard housing to
OPEN, then slide on flat blade guard, as
shown in Figure 36.
Slide Lock
Blade
Guard
Housing
Figure 36. Installing flat blade guard onto guard
housing.
28. Adjust cap screws installed in Step 26 to
make bottom of blade guard parallel with cast
iron table, tighten cap screws, then secure
lock knob shown in Figure 37.
29. Adjust cap screws, lock nuts, and hex bolts
on swing arm (see Figure 37) to position
blade guard parallel with blade slot, then
tighten all fasteners.
Lock Knob
Figure 37. Location of components for adjusting
blade guard to blade slot.
Model G0772 (Mfd. Since 05/15)
Flat Blade
Guard