Table of Contents
Advertisement
7.
Visually align mounting holes in sliding table
base and saw, then install (2) M14-2 x 45
hex bolts with (2) 14mm lock washers and (2)
14mm flat washers through into ends of table
base (see Figure 22). Finger tighten only, for
now.
8.
Push sliding table against parallelism adjust-
ment bolts (see Figure 22), then final tighten
hex bolts from last step. The parallelism
bolts are preset at the factory and should not
require any adjustment.
x 1
x 1
Figure 22. Location to install hex bolts in sliding
table base and saw.
9.
Install sliding table lever using (1) pre-installed
M6-1 x 20 button head cap screw and (1)
M6-1 hex nut (see Figure 23).
x 1
Figure 23. Sliding table lever installed.
Model G0772 (Mfd. Since 05/15)
Right Side
of Saw
Parallelism
Adjustment Bolts
Left Side
of Saw
Sliding Table
Lever
10. Move sliding table lever down to unlock slid-
ing table. Move table right to access center
mounting hole, located near saw blade.
11. Install (1) M14-2 x 45 hex bolt with (1)
14mm lock washer and (1) 14mm flat washer
through saw into center of table base (see
Figure 24). Finger tighten only, for now.
Cabinet Access Hole
Figure 24. Center bolt installed to secure sliding
table base to saw.
12. Re-install cover removed in Step 2.
13. Install end handle with (2) pre-installed M5-.8
x 12 button head cap screws and (2) 5mm flat
washers (see Figure 25).
14. Finish securing end handle with (2) M6-1 x 15
cap screws, (2) 6mm conical lock washers,
and (2) 6mm flat washers (see Figure 25).
x 2
Figure 25. End handle installed on front (right)
side of sliding table.
x 1
End
Handle
x 2
-27-
Advertisement
Table of Contents
