Grizzly G0772 Owner's Manual page 52

5. Pull blade cover toward you to open it. It is
held closed with magnets and just requires a
firm tug to open.
6. Insert arbor locking tool into hole, as shown
in Figure 89, and rotate blade by hand until
tool drops into place.
Hole
Figure 89. Using tool to lock main blade arbor
for blade change.
7.
Place rag over main blade to protect your
hands from slipping into blade teeth, then
loosen arbor nut by turning it clockwise (left-
hand threads) to remove it, the flange, and
the blade (see Figure 90).
Arbor Nut
Figure 90. Rotating arbor nut clockwise to
loosen when changing blade.
-50-
Tool Inserted In Hole
Flange
8. Install new blade, flange, and arbor nut in
reverse order from removal, making sure
upper blade teeth face RIGHT (see Figure
91), then tighten arbor nut.
Upper Teeth
Facing Right
Flange
Arbor
Nut
Figure 91. Order of assembly when installing
main blade on arbor.
9. Remove blade locking tool from table hole.
10. Close lower blade cover, reposition blade
guard over blade, then move sliding table
back to center of machine.
11. Check scoring blade alignment with main
blade, and adjust if necessary (see Aligning
Scoring Blade on Page 52).
Model G0772 (Mfd. Since 05/15)
Arbor