Table of Contents
Advertisement
5.
Turn main power switch ON (see Figure 66).
Main Power
Switch
Figure 66. Main power switch location.
6.
Push Emergency Stop button (see Figure
67), then twist it clockwise so it pops out.
When button pops out, switch is reset and will
allow operation.
Figure 67. Location of Emergency Stop button
on control panel.
7.
Verify saw is operating correctly by push-
ing main blade ON button (refer to Figure
3 on Page 5). Wait 5–10 seconds until
you hear a faint "click", then press scoring
blade ON button.
—When operating correctly, machine runs
smoothly with little or no vibration or rub-
bing noises.
—Investigate and correct strange or unusu-
al noises or vibrations before operating
machine further. Always stop machine and
disconnect it from power before investigat-
ing or correcting potential problems.
Model G0772 (Mfd. Since 05/15)
Emergency Stop
8.
Verify main blade is rotating clockwise (when
standing in front of machine) and scoring
blade is rotating counterclockwise (opposite
direction as main blade).
Note: You may need to stop the blade rota-
tion and watch them come to a stop to deter-
mine which direction they are rotating.
— If blades are rotating in wrong direction,
stop machine and DISCONNECT FROM
POWER! Phase of incoming power supply
is reversed. Open electrical panel door,
swap wires at "R" and "T" terminals (see
Figure 68), then close panel and recon-
nect machine to power.
Electrical Panel
Ground
R and T
Terminals
Figure 68. Up-close view of power supply
terminals inside electrical panel.
9.
Press Emergency Stop button on front of
machine to turn machine OFF.
Door
-39-
Advertisement
Table of Contents
