Grizzly G0772 Owner's Manual page 56

Calibrating Crosscut Fence
To accurately use the crosscut fence scale and
ensure the end-block does not contact the blade,
the distance between the crosscut fence and the
blade must be properly adjusted.
To adjust distance between crosscut fence
and blade:
1. DISCONNECT MACHINE FROM POWER!
2. Move crosscut table (refer to Positioning
Crosscut Table Along Sliding Table for
instructions) so fence end block is aligned
with center of blade (see Figure 102).
3" Mark
Figure 102. Example of fence scale calibration.
3.
Loosen fence scale lock knob shown in
Figure 103.
Scale Lock
Knob
Figure 103. Location of fence scale lock knob.
4. Place precision ruler against a blade tooth,
as shown in Figure 102, then adjust fence so
that 3" mark on fence scale is exactly 3" from
blade tooth, then re-tighten lock knob.
-54-
End Block
Positioning Crosscut Table Along
Sliding Table
The crosscut table can be positioned as neces-
sary along the sliding table (see Figure 104).
Figure 104. Crosscut table positions along
sliding table.
To position crosscut table along sliding table:
1.
DISCONNECT MACHINE FROM POWER!
2. Secure sliding table position with lock lever
(see Figure 105).
Figure 105. Location of sliding table lock lever.
Model G0772 (Mfd. Since 05/15)
Sliding Table
Lock Lever