Grizzly G0772 Owner's Manual page 33

30. Position crosscut swing arm so it is perpen-
dicular to sliding table (see Figure 38).
Swing Arm
Figure 38. Crosscut swing arm perpendicular to
table.
31. With assistance from other people, place
crosscut table on swing arm pivot pin, and
slide crosscut table onto sliding table rail, as
shown in Figure 39.
Crosscut Table
Figure 39. Attaching crosscut table to sliding
table rail and swing arm pivot pin.
Model G0772 (Mfd. Since 05/15)
Crosscut
Table
Swing Arm
Pivot Pin
Sliding Table
Rail
32. Loosen lock knob (see Figure 40) to loosen
cross support hold-down, slide long cross-
cut table support bar onto hold-down, then
tighten lock knob and install end caps.
Long Support
Bar
Figure 40. Crosscut support bar components.
33. Loosen pre-installed hex bolts on crosscut
table. Slide small support bar onto hold-
downs (see Figure 41), tighten both hex
bolts, then install end caps.
Short Support
Bar
Hold-Down (1 of 2
Figure 41. Short crosscut support bar installed.
34. Unlock crosscut fence lock handles (see
Figure 42), insert guide pins on bottom of
crosscut fence into front or rear crosscut
table holes, then tighten lock handles.
Guide Pin
Lock Handles
Table
Hole
Figure 42. Mounting crosscut fence to crosscut
table in front table holes.
Hold-Down
Lock Knob
Guide Pin
Table
Hole
-31-