Table of Contents
Advertisement
2
Installation
The following instructions are provided to help you to set up your camera quickly and easily. We
suggest that you read through these instructions before you unpack and set up your camera system.
2.1
Getting Started
2.1.1
Unpacking Instructions
We recommend that you save the original packing cartons for the cameras and accessories in case
you need to return or exchange an item.
We also recommend that you bench-test any equipment being sent to another location for field
installation to assure that everything is fully operational as a system.
2.1.2
Components List
Please begin by checking your order against the Components List shown below to assure that you
have received everything as ordered, and that nothing has been overlooked in the packing
materials. If any item is missing, please contact your JAI Inc. representative immediately.
•
TM-9730CL camera
•
Document download card (includes instructions on how to download the necessary
documentation and software)
2.1.3
Accessories and Options
Following is a list of additional accessories and options that may be required for your application.
Please check with your JAI Inc. representative before you install your camera to determine what you
might need.
•
Digital output cable
− 26CL-02-26 (Camera Link cable)
Note: For CL models, the control software is downloadable. Serial communication is through the
Camera Link cable. No additional accessories are required.
•
PD-12UUP series power supply (see Section 2.2.4 on page 7)
•
12P-02S power cable
•
Tripod Mounting Kit: TP-20
(for dimensions go to:
www.jai.com/EN/CameraSolutions/Products/Accessories/Pages/Home.aspx)
2.2
Camera Setup
2.2.1
Heat Dissipation
The TM-9730CL camera is a compact camera. Since all the electronics have been packed in a very
small package, the outer case of the camera gets hot due to heat dissipation. The TM-9730CL will
operate "stand alone", but the following suggestions are recommended for optimum performance.
•
Cooling fan to set-up positive air flow.
•
Mount the camera on a large heat sink (camera bracket) made out of a conductive material such
as aluminum.
•
Make sure the flow of heat from the camera case to the bracket is not blocked by a non-
conducting material like plastic.
•
Make sure the camera has enough open space around it to facilitate the free flow of air.
TM/TMC/RM/RMC-9730CL
Installation
3
Advertisement
Table of Contents
