Installation; Getting Started; Unpacking Instructions; Components - JAI RM-4200CL User Manual

2 Installation

The following instructions are provided to help you to set up your camera quickly and easily. We suggest that
you read through these instructions before you unpack and set up your camera system.
2.1

Getting Started

2.1.1

Unpacking Instructions

We recommend that you save the original packing cartons for the cameras and accessories in case you need to
return or exchange an item.
We also recommend that you bench-test any equipment being sent to another location for field installation to
assure that everything is fully operational as a system.
2.1.2

Components

When you receive your RM-4200CL series camera from JAI, the contents of the shipping box should include the
camera and a document download card. If either of these items is missing, please contact your JAI, Inc.
representative immediately. The document download card includes instructions and web locations for
downloading the datasheet, manual, and camera-control software. If you do not have Internet access, please
contact JAI to receive the material on a CD-ROM.
2.1.3

Accessories and Options

Following is a list of additional accessories and options that may be required for your application. Please check
with your JAI representative before you install your camera to determine what you might need.
•
PD-12U series power supply
•
12P-02S power cable
•
26CL-02-26 Camera Link cable
•
TP-20 Tripod Mounting kit
(for dimensions go to: www.jai.com/EN/CameraSolutions/Products/Accessories/Pages/Home.aspx)
2.2

Camera Setup

2.2.1

Heat Dissipation

The RM-4200CL is a compact 2K by 2K camera. Since all the electronics have been packed in a compact
package, the outer case of the camera can become hot due to heat dissipation. For optimal performance, JAI
recommends using a cooling fan to set up a positive air flow around the camera and following the precautions
below.
•
Mount the camera on a large heat sink (camera bracket) made out of heat-conductive material like
aluminum.
•
Make sure the flow of heat from the camera case to the bracket is not blocked by a non-conductive
material like plastic.
•
Make sure the camera has enough open space around it to facilitate the free flow of air.
2.2.2

Connector Pin Configurations

2.2.2.1 12-Pin Connector
The RM-4200CL has a 12-pin Hirose connector for power input and signal integration. Pin #1 is Ground and pin
#2 is +12V DC. The pin-out table is shown on the following page. Serial communication for camera control is
accomplished by means of the Camera Link connector on the rear panel of the camera.
RM/TM-4200CL Series
Installation 3