Connector Pin Assignment - DFI OPS100-SH Installation Manual

Connector Pin Assignment

The OPS+ Module enables the integration of a pluggable module and a
display panel by employing the defined interconnect based on the JAE and
HRS combo plug and their receptacle connectors. The right angle blind
mate plug connector (p/n: JAE TX25A-80P-LT-H1E) should be mated with
the receptacle connector (p/n: JAE TX24A-80R-LT-H1E); together, they
provide interfacing for the following functions:
Power: DC-IN +12V~+19V@12A max
Display Interface: 2*HDMI 2.0 (or DVI or DP, 4K at 60Hz)
Audio: left and right Channel
USB: 1*USB 3.0 and 3*USB 2.0
Control and Sensors: 1*UART and Consumer Electronics Control (CEC, note
that the OPS100-SH does not support this function)
Control and Management Signals: the OPS+ Module power status, power-
on via display panel, OPS+ Module detect, Consumer Electronics Control
(CEC), system fan control, and device
The following table lists the pin assignments of the 80-pin JAE connector:
Pins Pin Assignment
40 +12V~+19V
39 +12V~+19V
+12V~+19V
38
+12V~+19V
37
+12V~+19V
36
+12V~+19V
35
34 +12V~+19V
33 +12V~+19V/NC
32 GND
DVI0_HPD
31
DVI0_DDC_CLK
30
29 DVI0_DDC_DATA
28 GND
reset.
Description I/O Pins
(1)
80
Power -
79
Power -
Power - 78
Power - 77
Power - 76
Power - 75
Power - 74
73
Power/NC -
72
Ground -
DVI-D IN 71
DVI-D I/O 70
DVI-D I/O 69
68
Ground -
8
Pin Assignment Description
GND Ground
GND Ground
GND Ground
GND Ground
GND Ground
GND Ground
PWR_STATUS PowerGood
PS_ON# Pluggable Signal ON
PB_DET Pluggable Board Detect
Not Available Not Available
AZ_LINEOUT_R Audio-R ch
AZ_LINEOUT_L Audio-L ch
GND Ground
I/O
-
-
-
-
-
-
(2)
OUT(OC)
IN
OUT
I/O
OUT
OUT
-