Table of Contents
Advertisement
Installing the OPS100-SH into the OPS-DB
The OPS+ Module has an accompanying Docking Board and allows it to
serve as a standalone computing system. The plug and unplug mechanism
between the OPS+ Module and the Docking Board utilizes the combo
connector at the back of the module. Please use the following steps to
install the OPS+ Module into the Docking Board:
1. Align the OPS+ Module with the slot of the Docking Board and slide the
module into the slot. Note that the venting holes should face upward to
allow ambient airflow.
2. Secure the module by tightening the thumbscrews on the front panel.
Thumbscrew
3. Connect the included AC power adapter. Turn on the system by
pressing the power switch.
Thumbscrew
5
Power switch
Advertisement
Table of Contents
