Table of Contents
Advertisement
Installing the OPS100-SH into a Display
Integrating a computing system into a digital signage display is made easy
by standardizing the connectors and signals between an OPS+ Module
and an OPS-compliant display. Note that the OPS+ Module does not
support hot swapping; do not power on the display before the installation
is complete. Please use the following steps to install the OPS+ Module
into the display panel:
1. Align the OPS+ Module with the slot of the display and slide the module
into the slot. Note that the venting holes should face outward to allow
ambient airflow.
Venting area of the panel
2. Secure the module by attaching two screws on the front panel.
3. Power on the display panel. The OPS+ Module should be automatically
powered on.
Note:
The location of the OPS slot may be at the side or at the bottom of the display
panel depending on the design.
Mounting screw holes
4
Venting holes
Advertisement
Table of Contents
