Existing Chimney And Pre-Fabricated Element Chimney; Connection Between Stove And Steel Chimney; Requirements For Chimney; Connecting Piece / Top Outlet - SCAN 65-1 Assembly And Instruction Manual

14
Existing chimney and pre-fabricated element
chimney
If you intend to connect your stove to an existing chimney, it makes
sense to contact an authorised Scan dealer, or a local chimney sweep,
for advice. These experts will also let you know if your chimney needs
renovating.
When connecting a pre-fabricated element chimney, follow the manu-
facturer's connection instructions for the relevant chimney type.

Connection between stove and steel chimney

Your Scan dealer, or local chimney sweep, can advise you on choos-
ing a make and type of steel chimney (we recommend using JØTUL's
chimney system). This ensures that the chimney will match your
wood-burning stove. As a general rule, the length of the chimney
should not be less than 4 metres, measured from the top of the stove.
Specific weather or installation conditions might require a different
length.
Choosing the wrong length or diameter of steel chimney could im-
pair functionality.
Always observe the chimney vendor's instructions precisely.

Requirements for chimney

The chimney must be labelled T400 and G for soot testing.
A S S E M B LY

Connecting piece / top outlet

The stove is prepared from the factory for top outlet.
The connecting piece is placed loosely in the top outlet of the stove.
The gasket for the connecting piece and the screws for fastening the
connecting piece are in the stove's ash drawer.
Lift the top plate and connecting piece off the stove.
Mount the ceramic gasket on the connecting piece
Connecting
piece
Ceramic
asket
Scan 64
NAVN: EMNE:
MATERIALE:
DIMENSION:
C:\Working Folder\Designs\Scan 64\90064013.idw
STI:
NAVN:
MATERIALE:
Afmontage topplade + røgstuds
VÆGT:
N/A
AREAL:
Scan 63 Røgstuds med pakning
EMNE:
0,70 kg
VÆGT:
13
TG.NR:
30-08-12
N/A
DATO: SIGN
Krog Iversen & Co A/
DK-5492 Vissenbjerg
TG.NR: 90063020
03-06-09 BC
DATO: SIGN:
9