Existing Chimney And Pre-Fabricated Element Chimney; Connection Between Stove And Steel Chimney; Requirements For Chimney; Connection With 90° Elbow Pipe - SCAN 1010 Series Assembly And Instruction Manual

Existing chimney and pre-fabricated element
chimney
If you intend to connect your stove to an existing chimney, it makes
sense to contact an authorised Scan dealer, or a local chimney sweep
for advice. These experts will also let you know if your flue needs
renovating.
When connecting a pre-fabricated element chimney, follow the
manufacturer's connection instructions for the relevant chimney
type.

Connection between stove and steel chimney

Your Scan dealer, or local chimney sweep, can advise you on choosing
a make and type of steel chimney. This ensures that the chimney
will match your wood-burning stove. As a general rule, the length of
the flue should not be less than 3,5 m measured from the top of the
wood-burning stove.
Some weather or installation conditions might require another
length.
Choosing the wrong length or diameter of steel chimney could impair
functionality.
Always observe the chimney vendor's instructions precisely.

Requirements for chimney

The chimney must be labelled T400 and G for soot testing.
Connection with 90° elbow pipe
If you intend to use an elbow pipe with the Scan 1010 we recommend
the use of a curved elbow pipe to improve the draft.
If you are connecting your stove using a sharp elbow bend, the clea-
nout door should be in the vertical section, such that the horizontal
part can be cleaned through it.
Scan 1010
AVN: EMNE:
Curved elbow pipe
opstilling med knærør
A S S E M B LY
Combustion chamber lining
Scan 1010
NAVN: EMNE:
MATERIALE:
M3 NR.: DIM.:
C:\Working Folder\Designs\Scan 1010\91010046.idw
STI:
91010042
TG.NR:
Sharp elbow pipe
ovn med 90 gr røgrør
N/A
VÆGT:
N/A
AREAL:
Baffle plate
in steel
17
91010046
TG.NR:
21-09-2016 hms
DATO: SIGN:
Scan A/S
DK-5492 Vissenbjerg©
Baffle plate
in vermicu-
lite