Installing Ceiling Grid - Leica Rugby 55 User Manual

4.1
Applications

Installing Ceiling Grid

• Attach the Rugby to the wallmount bracket. The side with
the control buttons should normally be facing outward.
Tighten the bottom locking knob until the Rugby is
secured to the bracket.
• After mounting the first strip of ceiling trim at the desired
height, attach the wallmount bracket to the trim. Tighten
the locking knob on the top of the bracket.
• Press the On/Off Power Button to turn on the Rugby. The
Rugby will always turn on in automatic mode. Allow the
Rugby to self-level.
• Adjust the Rugby so that the rotating beam is at the
desired height below the ceiling grid. Loosen the adjust-
ment knob on the side of the bracket and slid the Rugby
up or down. When at the desired height, retighten the
adjustment knob.
• Install the ceiling grid. With the Rugby attached to the first
piece of trim and adjusted to the desired height, work can
begin. Attach the magnetic target to the ceiling grid and
adjust the height of the grid until the rotating or scanning
beam is striking the center of the target.
Rugby 55 4-2