Enabling The Remote Ui - Canon imageRUNNER ADVANCE C5051 Getting Started

Enabling the Remote UI

You must use the machine's control panel to enable the Remote UI.
By setting [Remote UI] to 'On' , you can open a necessary port. However, it is recommended that it is set to 'Off' , if a port is not used. If you
leave the port open, an unauthorized user may access the machine.
1
Press
2
8
Select [On] → select whether to use SSL .
Select [Off ] to disable the Remote UI.
<Use SSL>:
[On]: Allows secured transmission using SSL.
[Off ]: Prohibits secured transmission using SSL.
<Use Reference Print >:
[On]: Allows printing by entering its URL.
[Off ]: Prohibits printing by entering its URL
Any changes made to <Use SSL> are also applied to <SSL Settings> in <Use HTTP> in [MEAP Settings] in [Management Settings]
(Settings/Registration).
3
Press [OK] .
The selected mode is set.
4
Turn the main power of the machine OFF, wait 10 seconds, and then turn the power ON .
The [Remote UI] setting is made effective only after turning the machine's main power OFF, and then ON. For information on how
to turn ON and OFF the main power of the machine, see Chapter 1, "Before You Start Using This Machine. "
8-4
Before You Start the Remote UI
(Settings/Registration) → [Management Settings] → [License/Other] → [Remote UI] .