Before You Start The Remote Ui - Canon imageRUNNER ADVANCE C5051 Getting Started

Before You Start the Remote UI

Before starting the Remote UI, an administrator must perform the following:
■ Specify the Network Settings
Specify the settings under [Network] in [Preference] (Settings/Registration) and find out the machine's IP address. (See "Protocol Settings, "
on p. 4-3.)
■ Enable the Remote UI
Set [Remote UI] in [Management Settings] (Settings/Registration) to 'On' . It is also recommended that [Device Information Settings] in
[Device Management] (Settings/Registration) is configured.
•
Connection via a proxy server is not possible. If your system environment has a proxy server, perform the following setting. (Settings vary
according to the system environment, consult the administrator for the network you are using.)
- Enter the IP address of the machine into Exceptions in the web browser proxy server settings.
•
You must set your web browser to enable all cookies and use JavaScript. Otherwise, you will not be able to change the machine's settings
using the Remote UI.
•
If the control panel of the machine is being used for a particular operation and if you use the same operation on the Remote UI, the last
setting is activated.
•
If multiple Remote UIs are running simultaneously, the latest setting that was made is enabled. It is recommended that only one Remote
UI be running at a time.
•
To enter characters from a web browser, use the characters that you can enter from the touch panel display of the machine. If you use the
other characters, they may not be displayed/recognized properly on the machine.

Before You Start the Remote UI

8
8-3